A Angle
On This Page
Product Details
Our line of angles provides a way to make a wide range of 90° connections.
Material
- A21 and A23 — 18 ga.; all other A angles—12 ga.
Finish
- Galvanized. Some products available in stainless steel or ZMAX® coating. See Corrosion Information.
Installation
- Use all specified fasteners; see General Notes
Related Literature
Load Tables
Load Values with Nails
These products are available with additional corrosion protection.
Many of these products are approved for installation with Strong-Drive® SD Connector screws.
- See Straps and Ties General Notes.
- For SPF/HF lumber, use 0.86 x DF/SP allowable loads.
- Connectors are required on both sides to achieve F1 loads in both directions.
- Fasteners: Nail dimensions in the table are listed diameter by length. For additional information, see Fastener Types and Sizes Specified for Simpson Strong-Tie Connectors.
Model No. | Fasteners | DF/SP Allowable Loads | SPF/HF Allowable Loads | |||||||||||||
---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|
To Rafters/ Truss | To Plates/Base | To Studs/Post | Uplift | Lateral | Uplift | Lateral | ||||||||||
(160) | F1 (160) | F2 (160) | (160) | F1 (160) | F2 (160) | |||||||||||
|
||||||||||||||||
A21 | - | 2-SD9112 | 2-SD9112 | - | 430 | 165 | - | 360 | 140 | |||||||
A23 | - | 4-SD9112 | 4-SD9112 | - | 670 | 560 | - | 580 | 480 | |||||||
A33 | - | 4-SD9112 | 4-SD9112 | - | 830 | 335 | - | 715 | 290 | |||||||
A44 | - | 4-SD9112 | 4-SD9112 | - | 805 | 290 | - | 695 | 250 |
Code Reports & Compliance
Drawings
DWG | DXF | RFA | IFC | SAT | |||
---|---|---|---|---|---|---|---|